- Target Rings
- The centre of the bullseye sits in the centre of the middle 2X10 [note that a 2x10 is actually 9 1/2 inches wide thereby making the centre 4 5/8"]:
- Bullseye is 7" in diameter;
- Red (3 point ring) is 17" inches in diameter;
- Blue (1 point ring) is 27" inches in diameter . See image 3.2-A below
- If measured from the floor, the centre of the bullseye should sit 63" from the floor;
- Left or right side boards may be mounted at varying heights on the backboard to keep knots away from point areas:
- Side boards are always mounted blank so their height position does affect the location of the clutch or point areas.
- The centre of the bullseye sits in the centre of the middle 2X10 [note that a 2x10 is actually 9 1/2 inches wide thereby making the centre 4 5/8"]:
- Clutches* (TM)
- The diametre of the clutch is 2 5/8 inches;
- The innermost edge of the clutch sits 4 ¼ inches from the seam between the side and centre 2x10:
- this makes the centre of the clutch 5 ½ inches in from the seam, and 40 ¼ inches from base of the backboard. See image 3.2-B below
- The base of the clutch is 39 inches from the base of the backboard;
|
Image 3.2-A (sub-section 1.1.3): Target Ring Dimensions
|
Image 3.2-B (sub-section 2.2.1): Clutch Dimensions
|
|
|
*Clutch: the term 'clutch' is a registered trademark of BATL Global Corporation, used under license to the National Axe Throwing Federation and its members.
Comments
0 comments
Please sign in to leave a comment.